fransız kanallarında server açmama?

[Tarinos]

Next Pandora - newcamd - canalsat fr

http://youtu.be/mjIGmkXG60w

[mach1]

If u put newcamd n line to oscam.server 13 19 fr channels works but with cccam its not ok..

[Tarinos]

no with oscam N line not works because "oscam" is linked on emon with cccam
oscam must be linked directly on the receiver with DVBAPI and without emon

[mach1]

I put 13 bis n line to oscam and with oscam it works mate

[Tarinos]

canalsat fr on Astra 19° ?

[mach1]

Yes mate cfr and bis works ..

[mach1]

There is small trick mate put first your cccam c line to oscam.server than server2 or server3 your newcamd n lines for bis and cfr then restart oscam and receiver power off on and try again u will see it trigger the cccam and french channels will work..

[raef]

usta mach1

Nasıl konfigürasyon newcam mı?


copy in oscam server?

[reader]
label = server1
protocol = newcam
device = orbit2.dyndns.tv,12020
user = raef
password = raef
group = 1
emmcache = 1,1,2
cccversion = 2.3.0

Bu yapılandırma for newcam doğru mu?

[mach1]

[reader]
label = server1
protocol = cccam
enable = 1
device = serverurl,portnumber
user = username
password = password
group = 1
emmcache = 1,1,2
cccversion = 2.3.0


[reader]
label = server2bis
protocol = newcamd
enable = 1
device = serverurl,portnumber
key = deskey
user = username
password = password
group = 1

[reader]
label = server3cfr
protocol = newcamd
enable = 1
device = serverurl,portnumber
key = deskey
user = username
password = password
group = 1

[Tarinos]

thanks mach1; i will try this

[Tarinos]

i power off-on the receiver, and oscam don't run again :cuara: ----> i reset the receiver

[mach1]

Yes it needs reset, latest sw has a lot of blocking problems too..

[goss07]

Musí aktualizovat nejnovÄ›jÅ¡í verzi cccam 2.3.0 v EMON
otevÅ™ít francouzské kanály

[raef]

pls Eğitim verin

for open channel france in oscam whit newcam

[mach1]

Which channels did u tried mate ?